Shelco Stainless Steel Filter Cartridge, 10'', 20 Micron

Shelco stainless steel filter cartridges are often used for high temperature applications and/or highly corrosive applications. You are able to purchase them in a wide micron range, anywhere from 2 micron up to 840 micron are available. These filters can also be cleaned and reused at higher micron ratings. Lower micron rated filters may require ultrasonic cleaning to properly clean the filter.

- Ideal for high temperature applications up to 500°F and high differential pressures up to 60 psid
- 304L and 316L Stainless Steel construction for compatibility with a wide range of fluids
- 2 through 840 micron ratings for broad range of uses from fine filtration to straining
- Available in cylindrical and pleated configuration for cost effective and extra service life requirements
- Cleanable and reusable in most applications
- All welded construction provides higher mechanical strength cartridges


Applications
- High Temperature    
- Viscous fluids
- Caustic fluids
- Straining
- Petrochemicals
- Magnetic coatings
- Wastewater
- High differential pressures
- Corrosive liquids and gases
- Plating solutions
- Hydraulic oils
- Photo solutions
- Process water
- Chemical solutions

Specifications:
- Micron Rating: 20 microns
- Nominal Length: 9-3/4", 9-7/8", 10"
- Outside Diameter: 2-1/2" (Cylindrical), 2-5/8" (Pleated)
- Inside Diameter: 1-1/16"
- Gaskets/O-Rings: Buna, EPR, Teflon, Viton
- Materials of Construction: 304L or 316L SS
- Maximum Temperature: 500°F (260°C)
- Maximum Change-Out Differential Pressure: 60 psid
- End Cap Configurations: DOE, 222/flat, 226/flat, 1: MNPT, 1" FNPT